Introduction to the text
How to set Anti-Pass back for access control system on SmartPSS
This article will show you How to set Anti-Pass back for access control system on SmartPSS
Step by Step Instructions
Access controller must be added into SmartPSS client. You can click ‘Configuration / Devices’ to add it on the SmartPSS home page.
In Permission Management interface, click Anti-pass Back to set verification user. A user verifies at door A must verify at door A again when exits since card record must match one to one. If a user does not verify when enters, he/she will not pass verification when exits.
Click , select Anti-pass Back.
Click Add. The system displays the interface of Anti-pass Back.
Select the device which uses anti-pass back rule and set parameters.
Click ‘Next’ and the system displays the config interface of anti-pass back.
Search and select personnel by department, number or name.
Click OK. The system automatically issues data and anti-pass back setting is completed. Anti-pass back is enabled by default after it is set.