How to set Fast Moving Detection on SmartPSS

  121   SmartPSS

Introduction to the text

How to set Fast Moving Detection on SmartPSS

Description

This article will show you how to set IVS rule ‘Fast Moving Detection ‘on SmartPSS

Prerequisites

  • SmartPSS

Step by Step Instructions

In Smart Plan interface, select Next or config, here you can set IVS.

When a target moves at speed reaching preset value and duration of movement reaches preset time length, alarm is triggered.

Note:

Only when calibration of global variable is complete, fast moving judgment is accurate.

Step 1

Click Add rule.

Step 2

Enable rule and modify rule name and type.

1. Enable rule, means to enable corresponding IVS rule.

2. Modify rule name.

3. In Rule type dropdown list, select Fast-moving.

Step 3

In monitoring video, draw detection zone, and right click to stop drawing.

Note:

Select existing detection zone, click Clear or Re-draw to draw again.

Step 4

Set parameter, arm time and alarm link. Draw target filter.

ParameterNote
Min DurationMin duration from a target appears in detection zone to trigger of alarm.
SensitivityThe higher the sensitivity is, the easier to trigger alarm while more interference will be caused. Default setup is recommended.
SensitivityThe higher the value is, the easier it is to trigger alarm, but meanwhile it causes more disturbances upon alarm. It is recommended to adopt default setting.

Step 5

Click Apply.

LEAVE A COMMENT