How to set People Counting on SmartPSS

  170   SmartPSS

Introduction to the text

How to set People Counting on SmartPSS

Description

This article will show you how to set People Counting on SmartPSS

Prerequisites

  • SmartPSS

Step by Step Instructions

It is to count the people who enter and exit the detection area.

   1. Enabling People Counting

Step 1

Click Next after setting preset on the interface of Scene Config.

The interface of Smart Plan is displayed.

Step 2

Click and select the smart plan of people counting.

The smart plan is selected when the white frame appears next to the icon. If you select other smart plans (mutually exclusive with people counting), first it needs to click corresponding icon to cancel selection, then click to select smart plan of people counting.

    2. Configuring People Counting

Step 1

Click Enable and people counting is enabled. 

Step 2

Modify Rule Name. 

Step 3

Draw statistics area o in the monitoring image.

Step 4

Configure parameters, arm period and alarm linkage.

(1) Click Config to configure parameters.

ParameterDescription
Enter No.Alarm is triggered when enter No. exceeds threshold.
Exit No.Alarm is triggered when exit No. exceeds threshold.
Remaining No.Alarm is triggered when remaining No. exceeds threshold.
SensitivitySensitivity of control target. The lower the value, the less wrong detection will be, but missed detection will be more. Sensitivity is from low to high with scene from fewer to more

(2)Click Arming Schedule, select week and period according to actual requirement, input start time and end time.

Note:

The factory default arm time is 24 hours every time.

(3)Click Alarm and set alarm linkage mode

For parameter details, See the follow chart.

(4)Click Save.

Step 5

Click Save to save config.

LEAVE A COMMENT