how to setup SmartPSS Event pop-up Notifications for Motion Detection

  158   SmartPSS

Introduction to the text

SmartPSS 2.09 – Event Config Setup For MD Window Pop-up

Description

This guide will show how to enable motion detection via SmartPSS 2.09 for window pop-up

Prerequisites

  • SmartPSS installed
  • Recorders or cameras added in SmartPSS

Step by Step Instructions


1. Click “Event Config” on the main menu.

2a. Select the camera by left clicking it once.

2b. Select “Motion Detection” under Channel Event.

2c. Enabled “Motion Detect” once Motion Detect has been selected on the earlier step.

3. Click “Link Video” and select the cameras to be added onto the grid boxes.

Tip: If only one camera needs to be added then select one grid box only. Multiple grid boxes can be selected for more cameras.

4. Once motion is detected, another pop-up windows will appear and show the camera(s)’ live views. Please note that if there are more than one camera are selected previously, both cameras will show up regardless of motion on the second camera.

For example, the below image shows both cameras being up but there isn’t any motion on the first camera, however, it still shows up due to both cameras are added to the same grid box.

Important notice: If two cameras are setup separately (not on the same grid box), the pop-up windows still shares between them but only one camera can be seen at a time.

LEAVE A COMMENT