Step 1 Please login your camera on the browser by IP address. Step 2 Please click the icon of VCR on the main page, it will begin for once tape and stop for twice. Step 3 Please click the Setting>Camera>Video>Path, you can find the saved video over there.(Besides, you can change the storing path as ..
Step1 Please login your device on browser and go to Setting >PTZ>Function>Default, and click Default to reset it. Step2 After tape it，all the settings will clean under the PTZ..
We can set video bit stream parameters such as bit stream type, compression, resolution. Some series products support three streams: main stream, sub stream 1, sub stream 2. The sub stream maximally supports 1080p. Step 1 Select Main Menu>Camera>Encode Step 2 Configure parameters. Step 3 Click the resolution drop-down menu to select the appropriate resolution. As shown ..
H.264H, H.264, H.265 encoding modes can be supported, please select the corresponding encoding mode according to the actual interface. Step 1 Select Main Menu>Camera>Encode. The Encode interface is displayed. Step 2 Configure parameter. Step 3 Click the drop-down menu of compression to select. Step 4 Click Apply save to..
This function is enabled by default for main stream. you need to manually enable it for sub stream 1.Once this function is enabled the recorded video file is composite audio and video stream. In the Compression list , select a format : G711a , G71lu , PCM , AAC. In the Sampling Frequency list , ..
According to the network planning, set the IP address of the device to ensure the normal network connection between the device and other devices in the network. Step 1 Select Main Menu>Network>TCP/IP Step 2 Click icon to modify. Step3 Fill in the correct IP Address, Subnet Mask and Default Gateway. Step4 Click OK to save..
We can disarm all alarm linkage actions as needed by just one click. Step 1 Select Main Menu>Alarm>Disarming. Step 2 Select On for Disarming to enable disarming. Step 3 Select alarm linkage operation and only check the buzzer.All alarm linkage actions will be disarmed if you select All. Step 4 To disarm camera channels , select the check box at ..
Attention 1.The recorder support the custom add function. 2.The camera supports RTPS. Guidance： Step1 Please login and go to Maintenance>Camera>Remote device on web, Main menu>Camera>Remote device. Step2 Please select manual add, and input camera infos ( please fill in the infos like manufacturer/IP Address for RTPS/username and password, remember to choose Custom for the manufacturer) and click OK. Take an ..
Attention： 1.Make sure the NVR and the IPC have the network segment and no IP conflict Guidance： Step1 Please input the Hik address，Access Hik Vision camera web page Step2 Click Configuration-System-Security-Security Service(disable illegal login lock) NO check the box (Enable Illegal Login Lock) Step3 Click Configuration-Network-Advanced Settings(enable onvif) Check the box(Enable Onvif) Step4 Add the new ..
Attention： 1.Please ensure that the 3rd-party camera support ONVIF, and set the relevant protocol. 2.Make sure the NVR and the IPC have the network segment and no IP conflict Guidance： Step1 Please login the camera and go to Maintenance>Camera>Remote device Step2 Please choose manual add, and input the camera infos（3rd-party camera IP address、3rd-party camera HTTP ..